Welding Hand Torch SIngle Torch 207ST Brazing Soldering Propane MAPP c/w Ignitor

FEATURES

SELF-IGNITION
NOZZLE SWIVELS 360
MADE OF BRASS AND STAINLESS STEEL
DUAL GAS MAPP OR PROPANE
FITS ALL STANDARD MAPP OR PROPANE TANKS
100% FIRE TESTED
FUNCTIONS

BRAZING & SOFT SOLDERING
OXYGEN CYLINDER IS NOT NEEDED
CGA600 CONNECTION
HIGH WORKING TEMPERATURE
ADJUSTABLE PRESSURE
CAUTIONS

THE TORCH IS FOR USE WITH MAPP OR PROPANE GAS
THE TORCH IS FOR USE WITH 14OZ OR 16OZ CYLINDER
KEEP CYLINDERS UPRIGHT WHEN IN USE
THE OUTPUT GAS WILL BE REDUCED UNTIL THE TORCH IS CLOSED WHEN THE ADJUSTING SCREW OF REFULATOR IS TURNED CLOCKWISE (MOVING UPWARD) AND THE OUTPUT OF FAS WILL BE INCREASED UNTIL IT REAHES MAXIMUM WHEN THE ADJUSTING SCREW IS TURNED COUNTER CLOCKWISE (MOVING DOWNWARD)
THE TORCH AND CYLINDERS MUST NOT BE USED AT A CLOSED SPACE.
LOW FLAME SETTING WILL RESULT IN OVERHEATING. 
OPERATION PROCEDURE

Confirm first the torch is suitable for use with the gas and pressure
The thread of the torch that is used to connect the cylinder meets CGA600
Use hand to connect the torch to the cylinder properly by screwing it on the cylinder
Make sure there is no leakage of the connection between the torch and the cylinder and no leakage of the torch by using proper leakage testing ways mentioned belowe. 
Turn the adjusting screw counter clockwise, at the same time, push the igniting trigger until the torch is ignited. 
Adjust the adjusting screw until the flame meets your requirement
Turn the adjusting screw clockwise until the flame goes off and the torch is fully turned off
After usage, turn off the torch, turn the adjusting screw to the close position, disconnect the torch from the cylinder, and put the cylinder at a plave in open air where children could not reach. 
for more information on the use of cylinders, please refer to cylinder manual.